Uses one main circuit board for easy maintenance.
Accurately calibrated digital torque settings with a resolution of 1 watt makes torque settings accurate and can be easily reproduced for identical results.
Soft start has been provided for all drives. This feature reduces starting currents in the drive. As a result, life of carbon brushes and drive increases.
Connected drive is automatically recognised and indicated by means of LED on the torque controller.
Trip time adjustable from ( 0 sec to 10 secs.).
Adjustable reverse time from ( 0 sec to 90 secs.).
Drive toque adjustable in reverse rotation with surface to set torque.
Hand (trigger) mode or foot switch mode, both are available.
Expansions can be carried out either in single cycle mode or auto repeat mode.
Automatic indication on the display for controllers tripping due to voltage or current fault.
Electronic over current protections incorporated for all four drives.
Over voltage protection at 275 volts and Under Voltage protection at 180 volts.
Supply voltage value displayed during pause time of every auto cycle.
Drive current indication given during manual reverse operation.
The no. of expansions are stored in the memory and displayed on the panel display at power ON and also whenever the panel is idle.
Trip valves are stored in memory after expansion and can be reviewed any time.
The trip values can be transferred to PC (Computer) using a single key HANDSET.
Using specially developed software, the DATA can be analyzed in statistical terms.
It also plots a histogram of No. of tubes verses percentage over-expansions.
The Minimum and Maximum supply voltage values observed in the period after last memory RESET, are also displayed.
Power consumption of control circuit reduced to 50% which leads to enhanced panel life.
Single key HANDSET makes it very easy for the operator to transfer DATA to the computer.